Indicator of oil products
Model INPF-01 EP
The indicator of products Solar (fluorimetric) is intended for determination impurity of fresh water and sewage by oil products also for definition of combustion products remains
- It is compact (0,5 kg)
- Operates in field conditions (from accumulators)
- Measurement time is 5-30 seconds
<<<
>>>
Scope
The indicator of oil products INPF-01 EP is demanded in such areas as fire investigation, judicial examination, laboratories of environmental control. Also the indicator of oil products can be used at examination of the fires as an express tester to determination of oil products content in burning productsCompactness
Small-sized and easy (weight is no more than 0,5 kg)Express analyzer
Fast obtaining result. Reagents aren't required. Time of measurement is 5-30 secondsEasy-to-work
The special target tablet should be put to water, then to place to measuring cell of the indicator and to press "Start". Result will be on screen device in 5 secondsOperates from accumulators
It is suitable for work in field conditions. It can operate from accumulators the long time even at low air temperature (not less than 2 hours)Built-in memory
Saves 100 measurementsDelivery set
- Fluorimetric indicator of oil products INPF-01 EP
- Network adapter
- Tablets targets for measurements – 1000 pieces
By the additional order
- Tablets targets in any quantity
- AAA 1000mAh accumulators
- Charging device
| General principles | fluorimetric |
| Threshold of oil products in water definition sensitivity | 0,1-50 mg/dm3 |
| Results of measurements | the four-lower case display in relative units |
| Range of measurements | 0 - 1000 relative units |
| Source of initiation fluorescence | light-emitting diode with max. wavelength of the radiation 270 nanometers and half-width of spectral interval radiation of 15 nanometers |
| Radiation receiver | silicon diode |
| Spectral interval of registration fluorescence | 300 - 420 nanometers |
| Time of operating mode setting from the moment of indicator switching | no more than 1 minute |
| Time of continuous work: - at turning on of the indicator - during the operation in the autonomous mode | continuous, not less than 2 hours |
| The tablet target sizes for measurement | diameter 10х1mm 15x15x1mm |
| Dimensions | 105х180х60 mm |
| Weight | 0,5 kg |
| Power supply | 230+-23 V, 50+-0,5 Hz, 1 VA AAA 1000mAh accumulators – 2 pieces |